2x Freematics ONE+ Traccar Edition aren't working

[trackernsw]

I'm back from the car.

Still the same problem.

One is working but receiving the wrong GNSS signal its showing Latitude = 0.000000°Longitude =0.000000°
The second one is not working at all

[trackernsw]

When i changed the line on the FreematicsPlus.cpp (the library, ticked the rebuild libs. after building. then selecting the COM3, there is a blank screen no outputs are given.

[stanley]

Freematics Builder version 1.2 was just released. I suggest you doing an upgrade. If still no luck, please use PlatformIO or Arduino IDE.
https://github.com/stanleyhuangyc/Freem ... ag/builder

[stanley]

If you still see GNSS:NO there shouldn't be any coordinates. Can you confirm you've got GNSS:OK?

[trackernsw]

Good morning,

Regarding the new version of Freematics Builder, should i also change the value for #define VERBOSE_XBEE 1 in FreematicsPlus.cpp (the library)

Regarding the GNSS, it was supplied by you, my Order 13289.

[stanley]

Yes both.
All your parts were tested together before shipping. Could you take a picture of your devices when you test them?

[trackernsw]

Hi Stanley.

Your new update is generating errors. Please see attached.

Also, the config settings are different on this new version, can't select sim apn, external gnss, ....

When can I start tracking my vehicles its been more than 1-2 weeks now.

[stanley]

That issue was fixed. Please download and install version 1.2 again. Please also update your code from github.

[trackernsw]

I don't think so the problem is solved yet.
*downloaded the latest code from GitHub and reinstalled the builder too.

(I need to get this tracker by working tomorrow lastest.)

[stanley]

Please use PlatformIO or Arduino IDE if you can't get our utility to work which is provided as a courtesy.