Problem when setting more than one DTC code

[Alex4WAG]

Hello,

I received your OBD-Emulator MK2 this week. This is a very nice tool
Unfortunately I experienced a problem when setting more than one DTC-code.
Although the GUI confirms that more than one code is set simultanously, I do only get one DTC-code when checking with an OBD-tool.
This is a function that I urgently need for my development work.

Can you help?

Regards,

Alex.

[stanley]

Just set one more time to add a DTC code. Up to 6 DTC codes can be set.

[Alex4WAG]

Hi Stanley,

that is exactly what I am doing.

For example after setting 3 different DTCs the GUI confirms with "Totally 3 DTCs has been set".
But when checking with a fault code reader only the last DTC ist set.

When checking with a CAN-tool my request is: ($7df) $01 $03
The reply then is: ($7e8) $04 $43 $01 $03 $00
Fault codes 0100, 0200 and 0300 should be set.

Can you help?

[stanley]

Can you try upgrading with latest firmware which has just been released?

[Alex4WAG]

Yes, I did but the problem persists with the firmware dated Dec. 9th.

[cavalier]

I am facing with this problem too. I have updated firmware but the problem isn't fixed yet.

[chad.schnitz]

I am having the same issue <p>

Only the last code shows

Freematics1.png (127.14 KiB) Viewed 19057 times

4 DTCs entered

freematics3.png (174.08 KiB) Viewed 19057 times

[bernardofca]

Same problem here.

At least please acknowledge the problem and suggest a target resolution date.