Page 1 of 3
Set MIL to Off ?
Posted: Tue Nov 25, 2014 10:48 am
by itsmagic
Has anyone determined a way to set MIL off? As other have mentioned, with the latest 8/20 GUI and firmware,
MIL is on (with several freezeframes stored). Is it possible to force MIL off through the serial port via the ATSET
interface? Does anyone have a incantation to do so? Thanks for any help.
Re: Set MIL to Off ?
Posted: Sat Dec 13, 2014 3:37 am
by itsmagic
The new (December 9) firmware looks good. However, after updating the firmware and clearing DTC's,
MIL is still set ON and there is still a freezeframe stored with six DTC's. Stanley, is this working as designed
or will it be fixed? Thanks.
Re: Set MIL to Off ?
Posted: Mon Jan 12, 2015 7:25 am
by ngolden
I am also having similar issues. The mil status is always on and there seem to be 6 dtc's stored in the system, but when scanning it they don't show.
can this be fixed?
Re: Set MIL to Off ?
Posted: Thu Jan 15, 2015 7:34 pm
by g35driver
Does anyone know how to turn MIL off yet?
Re: Set MIL to Off ?
Posted: Fri Feb 27, 2015 8:04 am
by g35driver
Anyone? I'm getting so fed up with this lol
Re: Set MIL to Off ?
Posted: Wed Mar 04, 2015 5:56 am
by zeus
Same problem here! When will there be a fix available?
Re: Set MIL to Off ?
Posted: Wed Mar 04, 2015 9:54 pm
by Halide
Somebody?? Stanley?
Re: Set MIL to Off ?
Posted: Tue Mar 24, 2015 8:59 pm
by g35driver
STANLEY!!!!! Can I return this paperweight? Or can you do something about this problem
Re: Set MIL to Off ?
Posted: Wed May 06, 2015 7:11 am
by ericboehs
Have you tried sending
via serial?
Re: Set MIL to Off ?
Posted: Thu May 07, 2015 7:13 am
by itsmagic
ATCLR DTC is accepted, but MIL stays on and the stored DTC's are still present after doing it... so no good.