Nano Kit, Can't Upload

[AustinBob]

I am having a hard time getting anything to upload to the Nano; even blink. I'm on Windows and it sees it attached as COM6. It sees that it is a CH340. But no matter what programmer I select in the IDE, it gets an error. (I am able to upload to an Uno I have sitting here.)

Uploading with AVR ISP
Using Port : COM6
Using Programmer : stk500v1
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x03

Uploading with AVRISP MKII
Using Port : usb
Using Programmer : stk500v2
An error occurred while uploading the sketch
avrdude: usbdev_open(): did not find any USB device "usb" (0x03eb:0x2104)

Just an Upload
Using Port : COM6
Using Programmer : arduino
Overriding Baud Rate : 115200
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xf2

[stanley]

Did you connect OBD adapter to the nano board when uploading?

[AustinBob]

No I did not. I finally got it to upload using the "ATmega328P (Old Bootloader)" processor and the "AVRISP mkII" programmer. Now to try and add the Toyota PID for transmission temp.

Thanks.

[AustinBob]

It was not connected. I was able to get it working by using a different processor. The "ATmega329P (Old bootloader)" is the one that worked. The programmer was still the AVRISP mkii.

Now I need to figure out how to add the PID for the Toyota transmission.

Thanks!