Hello Everyone,
Has anyone had any luck or advice on setting up the Freematics ONE+ as a datalogger and then retrieving the data via the Bluetooth connection.
I have tried the Telelogger sketch but have not been able to find a Bluetooth connection from a windows 10 laptop, it is possible I have not set it up correctly, I had to use PlatformIO to program the Freematics ONE+, and afterwards when I opened the com port using the Audino Builder I just seem to see a lot of ":0" with a few :1 upto :4 thrown if for good measure, I have not yet tried to work out what they mean.
Atleast when I loaded the Datalogger sketch into the Freematics ONE+ I was seeing an output about how many samples had been written to the SD card.
Any advice greatly appreciated
Regards,
Bevan