I am trying to read a PID with my custom PCB. The emulator is getting my request, but delivers no response (confirmed with a logic analyzer). Wiring is extremely short (10cm).
This is my complete terminal session (I'm eagerly waiting for the Linux version of the GUI):
OBD-II EMULATOR V1.2
ATBUS CAN_11B_250K
OK
ATSET 010C=2000
OK
ATINF1
OK
REQ: 00 00 07 DF 02 01 C0 00 00 00 00 00
REQ: 00 00 07 DF 02 01 C0 00 00 00 00 00
Emulator is not responding to CAN requests
Re: Emulator is not responding to CAN requests
Have you had your design proved? The emulator definitely works with CAN bus.