Switching over to try out cellular GNSS seems to not work with getting latitude using telelogger. I'm testing using an antenna connected to the cellular module.
GNSS is active and the serial console shows GPS data being collected: [GPS] 32.XXXXXX -117.XXXXXX 0km/h Course:46 2020-10-30T22:55:20Z
within telelogger it appears to only get latitude. I tried to look over the code but not really sure why it acts different from the External vs Internal GNSS.
Anyone have this issue?
Issues using Cellular GNSS
-
cmendes0101
- Posts: 14
- Joined: Wed Jul 29, 2020 1:06 pm
Re: Issues using Cellular GNSS
Nevermind, totally an issue on my side. The buffer became full right after adding lat when using the cellular GNSS. Console does print "Full" which I didn't notice was related.
The external GNSS performs better but I'm having GPS signal issues on multiple vehicles due to where the OBDII port is located so trying out other setups
The external GNSS performs better but I'm having GPS signal issues on multiple vehicles due to where the OBDII port is located so trying out other setups