Hi
I have the J1850 option emulator, and tried to update the firmware to get around what I think may be a bug.
Update reported success, but now I can't connect.
Any ideas?
Gareth
Can't connect after firmware update
Re: Can't connect after firmware update
--- RESOLVED ---
While it always programmed the new firmware okay, it would not connect to the app and was for all intents and purposes dead.
I contacted Stanley and he asked if the LED was on, which it was not.
Having already tried removing the DC and USB a few times to no avail, I tried removing the PSU from power and plug back in...this worked and all is okay now.
So perhaps the PSU went into a safe mode / over current mode caused by programming?
I would like to add that Stanley offered to send me a new one as soon as I could send proof of shipping the old one back - not many companies will do this!
Regards,
Gareth
While it always programmed the new firmware okay, it would not connect to the app and was for all intents and purposes dead.
I contacted Stanley and he asked if the LED was on, which it was not.
Having already tried removing the DC and USB a few times to no avail, I tried removing the PSU from power and plug back in...this worked and all is okay now.
So perhaps the PSU went into a safe mode / over current mode caused by programming?
I would like to add that Stanley offered to send me a new one as soon as I could send proof of shipping the old one back - not many companies will do this!
Regards,
Gareth
Re: Can't connect after firmware update
Good to know the cause of your issue. 