Hello
Does anyone have a simple sketch that proves we've successfully uploaded code to the adapter?
We've tried using USBasp and ArduinoISP without any success. Our attempts at running simple code (e.g. turning an LED on/off) via the Freematics aren't working. However, we're able to do this on our Arduino UNO using L (13). Using ISP it reports a successful upload, but there's no response from the adapter. Any suggestions would be welcome.
Many thanks
The basics
-
thisiseasy
- Posts: 2
- Joined: Tue Dec 16, 2014 8:26 am
Re: The basics
Hello,
can I please have some support with this product. I see a number of people with the same issues as us but no definitive setup/getting started guide appears to be available. We have given up on the usbasp and are now trying the avrisp. WE have wired it up correctly and have 3 leds to indicate what is happening. As soon as we try and deploy anything to the card we get a red led error and the following message -
avrdude: stk500_getsync(): not in sync: resp=0x00
Any help is very much appreciated.
Thanks.
can I please have some support with this product. I see a number of people with the same issues as us but no definitive setup/getting started guide appears to be available. We have given up on the usbasp and are now trying the avrisp. WE have wired it up correctly and have 3 leds to indicate what is happening. As soon as we try and deploy anything to the card we get a red led error and the following message -
avrdude: stk500_getsync(): not in sync: resp=0x00
Any help is very much appreciated.
Thanks.