Freematics Forum

Hi rhobison,

Is there any direct AT command which can be used to disable a PID specifying PID value in HEX with enable or disable parameter.
Or we have to use same logic as defined in your GUI software source code.

Thanks in advance.

Hi rhobison,

Is there any command available which can be used to enable/disable PID like other AT cmd to set PID values, Clear DTC. Using GUI this functinality is achieved but what if i want to do it programmatically.

Thanks in advance.

Make sure you have driver installed in your system.
http://www.silabs.com/products/mcu/page ... ivers.aspx

Also follow below instruction to connect to emulator and launch freematics application.
Section "Getting started" at http://freematics.com/products/freemati ... lator-mk2/

Thanks Jonathan for your response. I have a query. When we trigger Ignition off from emulator and trigger Ignition On again then dongle are not able to receive Ignition On event. We need to power cycle dongle to trigger Ignition ON event, have you faced similar problem or for you ignition on/off eve...

Hi Jonathan, Can you share some detail about your library. I have tried to browse about writing script for AT command but not able to figure out proper tutorial. Do you have any reference link where i can read and write script which will execute AT commands on emulator. I don't have any background o...

I am also having same issue, can anyone help on that ?
Pressing Ignition ON doesn't work many times even though in console it shows that AT command executed successfully. Most of time response from Emulator to dongle take more then 5-6 minutes for Ignition ON command i.e ATACC1.