Page 1 of 1
ELM327 Connecting to Emulator
Posted: Mon Sep 30, 2024 10:22 am
by cptreese
I just got my emulator in, super excited, I was hoping to connect this emulator to an ELM327 but it can't find the protocol. Any tips on how to get this working?
Re: ELM327 Connecting to Emulator
Posted: Wed Oct 16, 2024 1:34 pm
by fruitoperation
Ensure the emulator is set to simulate a car's OBD-II protocol properly. Most emulators allow you to select a specific protocol, such as ISO 9141-2, CAN, KWP2000, or others. Make sure the emulator is set to a protocol supported by the ELM327 device.
Re: ELM327 Connecting to Emulator
Posted: Mon Nov 11, 2024 10:49 pm
by bev10
To connect an ELM327 device to an emulator, ensure that the emulator supports OBD-II protocols.
xfinity customer support billing Use compatible software (like Torque or Car Scanner) on your PC or mobile device, and connect via Bluetooth or USB. Follow setup instructions for proper communication.
Re: ELM327 Connecting to Emulator
Posted: Wed Nov 20, 2024 9:47 pm
by alk
Hello there, wanted to know if got any results trying to connect elm327 to emulator. I have tried several lectors for CAN traffic but emulator only seems to be sending CAN messages with all 0 data, even after modifying values using Freematics GUI or raw AT commands.