How to check sendCommand's functionality
Posted: Wed Dec 27, 2023 1:43 pm
Hello ,
My purchase was Freematics ONE plus.
Firmware_v5\datalogger was the one I used.
outcome SD: NOT
OBD: Negative
SendCommand("ATI\r",...) in OBD sys.begin -> getDeviceType()
sendCommand did not respond.
ATI commands function normally if you have an ELM327 device and attach it to a vehicle.
It doesn't seem to be a wiring issue with the OBD.
Is it possible to determine whether the Freematics product has an anomaly?
Best
My purchase was Freematics ONE plus.
Firmware_v5\datalogger was the one I used.
outcome SD: NOT
OBD: Negative
SendCommand("ATI\r",...) in OBD sys.begin -> getDeviceType()
sendCommand did not respond.
ATI commands function normally if you have an ELM327 device and attach it to a vehicle.
It doesn't seem to be a wiring issue with the OBD.
Is it possible to determine whether the Freematics product has an anomaly?
Best