Freematics Forum

Hi There,

I have a problem with the emulator command set:

"ATSET DTC=P0105,P0106" is working fine and quitted with "OK"

"ATSET DTC7=P0105,P0106" and "ATSET DTCA=P0105,P0106" ist quitted with "ERROR".

Can somebody help?

Regards,

Alex.

Your emulator must have J1850 support to work with mode 7 and mode A.

Thanks, I am afraid mine does not. With J1850, will it support mode 07 and 0a with CAN protocol, too?
Is there any way to update my device?
Which J1850 protocol do I have to order to get mode 07 and mode 0a running with CAN?

They are different hardware and not upgradable by software.

Hi all, same question here, I am unable to set a pending DTC (mode 07), the button in the GUI is greyed out, and when trying it through the serial port I also receive 'ERROR’. Mode 03 DTC’s work fine. The emulator does have J1850 mentioned on the connector. Any clues? Would be great to get this working.

Thanks, but which J1850 protocol do I have to order to get mode 07 and mode 0a running with CAN?

Yes you can.

You are offering two options: J1850 PWM and J1850 VPW. Which one do I need to get mode 07 and mode 0a running with the serial commands?

Both will do.