Page 1 of 1
USBasp wiring has been updated
Posted: Sun Sep 13, 2015 8:05 pm
by stanley
As our USBasp vendor has changed, the wiring has been updated for the new batch.
If you experience problem with USBasp uploading, please change the GND wire (illustrated in purple color) as above.
Re: USBasp wiring has been updated
Posted: Mon Sep 14, 2015 5:31 pm
by Xavali7
I tried programming with the USBasp you provided, but it wasn't working properly since minute 1, and I tried plenty. Finally, I settled for using an Arduino UNO as an ISP, and that kinda works, but with extremely long loading times.
PS: Could you take a look to any of my issues on this forum, please? I have posted 3 issues, and none have recieved a reply...
Re: USBasp wiring has been updated
Posted: Thu Sep 17, 2015 11:28 am
by stanley
Have you change the wire of GND to pin 1 of USBasp as shown in the new wiring diagram? It should really work. Arduino as ISP is slower.
Re: USBasp wiring has been updated
Posted: Fri Sep 18, 2015 5:08 pm
by Xavali7
Soryy, I wasn't clear, I bought it from you months ago, long before you changed your provider. I wired it how the User Guide indicated then, and nothing... My issue is not with that, I was only letting you know! (my programmer was an ATmel Brand, blue)
My issue is with my other posts!
Re: USBasp wiring has been updated
Posted: Tue Sep 22, 2015 1:05 pm
by stanley
Just follow the latest wiring diagram.