Page 1 of 1
STM32F103C8T6 Programming
Posted: Thu Nov 20, 2014 1:22 am
by James Shim
I am a new people in this project. My question is if we need any firmware programming for this chipset. Or does the ATMEGA chipset take OBD-II data from it?
Re: STM32F103C8T6 Programming
Posted: Fri Nov 21, 2014 12:36 pm
by stanley
You only need Arduino programming.
Re: STM32F103C8T6 Programming
Posted: Sun Dec 21, 2014 4:16 am
by Marek
Hi,
Is it possible to access the stm32 firmware in order to reprogram it for use with pwmj1850
I would *only* need pwmj1850
Re: STM32F103C8T6 Programming
Posted: Sun Dec 21, 2014 11:10 am
by stanley
Sorry j1850 can't be supported. It's not about upgrading firmware.
Re: STM32F103C8T6 Programming
Posted: Fri Dec 26, 2014 6:22 am
by Marek
Hi Stanley,
it seems the atmega chip has got everything needed in order to implement both j1850pwm and j1850vpw what is the actual problem in not supporting these protocols?
Re: STM32F103C8T6 Programming
Posted: Sun Dec 28, 2014 6:35 pm
by Marek
I found a 10-pin header inside the datalogger - is it the 10-pin header for the STM32 chip?
Re: STM32F103C8T6 Programming
Posted: Fri May 27, 2022 12:16 am
by ankostis
For the interest of those landing here, J1850 pins 2/10 are not even connected to any ICs in the freematics ONE+ B/H.
Correct?
But in general, these standards are deprecated, and newer cars don't even support them; the focus is on ISO 15765, pins 6/14 (including ISO 14229-3 for UDS), correct?
Re: STM32F103C8T6 Programming
Posted: Fri May 27, 2022 8:58 am
by stanley
Neither model B or model H supports J1850.