Freematics Forum

Hi Stanley,

Would it be fair to say that one could plug your emulator into the adapter and run closed loop tests to check the "norms" for certain PIDs?

We'll be developing some telematics based on OBD's CAN bus for our wider ranging tracking and workforce applications and you are providing an excellent starting point.

I am excited about the work you are doing with the Arduino as this is an area that I've been also researching lately.

Should all communications come through the forum or do you ever correspond directly?

Sam Talbot

Could you be more specific for "check the norms for certain PIDs"?

I was simply asking if my assumption that the emulator outputs typical values for a range of IDs and that these can be then monitored using the adapter as if it was connected to a vehicle. I'm assuming that you can set the levels of the available PIDs and if these differ substantially from a "normal" range of readings, the adapter will pick up on that?

I'm going to go ahead and buy a couple of sets anyhow as this looks to be the most useful tool I've come across yet.

regards

sam

You assuption is right. If you need to set which PIDs the emulator is to respond, this feature will be added soon with a firmware upgrade.

I am on skype from time to time. The live chat link on the pages of Freematics Online Store will take you in.