Hi
I seem to be having problems with the MIL/DTC engine in the emulator.
If I set a DTC through the app and then clear the DTC through the app, all works ok.
If I set a DTC through the app, and then clear the DTC via the 0x04 MODE command then the following happens:
1. The number of DTC's are ...
Search found 3 matches
- Wed Nov 25, 2015 9:12 pm
- Forum: Freematics Products
- Topic: MIL / DTCs
- Replies: 1
- Views: 8278
- Wed Nov 25, 2015 9:06 pm
- Forum: Freematics Products
- Topic: Can't connect after firmware update
- Replies: 2
- Views: 9884
Re: Can't connect after firmware update
--- RESOLVED ---
While it always programmed the new firmware okay, it would not connect to the app and was for all intents and purposes dead.
I contacted Stanley and he asked if the LED was on, which it was not.
Having already tried removing the DC and USB a few times to no avail, I tried removing ...
While it always programmed the new firmware okay, it would not connect to the app and was for all intents and purposes dead.
I contacted Stanley and he asked if the LED was on, which it was not.
Having already tried removing the DC and USB a few times to no avail, I tried removing ...
- Wed Nov 25, 2015 9:23 am
- Forum: Freematics Products
- Topic: Can't connect after firmware update
- Replies: 2
- Views: 9884
Can't connect after firmware update
Hi
I have the J1850 option emulator, and tried to update the firmware to get around what I think may be a bug.
Update reported success, but now I can't connect.
Any ideas?
Gareth
I have the J1850 option emulator, and tried to update the firmware to get around what I think may be a bug.
Update reported success, but now I can't connect.
Any ideas?
Gareth