Freematics Forum

Hi all,

Is it possible to connect the ONE+ to an external CANbus via the molex connector? I can't figure out from the schematic whether the pins go to the coprocessor or not. In my vehicle the OBD canbus is useless, you need to wire into separate bus connectors.

Thanks!
James.

Hi Stanley, Thanks for responding! Uploading with PlatformIO doesn't seem to make any difference. I also tried to upload a simple Blink sketch with Arduino and that had the same behavior, so I don't think the issue is with the code in telelogger. I did a little more digging, but before I get into it...

Hi folks, I'm just getting started with Freematics - I've managed to grab the telelogger code and I'm using the Arduino Builder to flash it. Everything works fine as long as the ONE+ is connected to the Builder and the serial port is open, but if I just supply power (eg by plugging it into my OBD po...